RB3-0044-000CN is represented by #16 in the diagram below.
10
RB3-0010-030CN Plate
Feed plate - Center metal plate with slots that the ribs on the middle frame assembly go through
13
RB3-0016-000CN Spring
Electrical contact spring - Spring steel wire with compression springs formed on both ends
2
RB1-8668-030CN Belt
Feed guide drive belt - Small belt approximately 5/16 inch wide with 'A' shaped ribs on it
26
RG5-6939-020CN Roller
Registration roller assembly - Includes the roller, bushings, mounting plate, paper sensor, and the sensor flag
28
RG5-6940-050CN Shutter
Registration shutter assembly - Includes the metal roller, mounting frame, grounding springs, and the dual coupling gear
29
RG5-7122-000CN Cable
Cable assembly - 'Y' type cable (three connectors) - The 14-pin connector splits into an 8-pin connector and a 6-pin connector
3
RB3-0061-000CN Pulley
Pulley roller (accommodates three feed belts) - Small black roller approximately 3.49cm (1-3/4 inches) long with three ball type pulleys
31
RB3-0065-000CN Plate
Contact plate - copper clad metal spring - Holds the left end of the small 500 Meg-ohm resistor
32
RB3-0066-000CN Plate
Contact plate - copper clad metal spring - Holds the right end of the small 500 Meg-ohm resistor
36
RB3-0067-000CN Pulley
Pulley roller (accommodates one feed belt) - Small black roller approximately 1.59cm (5/8 inch) long with one ball type pulley
4
RB3-0063-000CN Belt
Paper feed belt - Small black rubber belt approximately 1/8 inch wide with little 'A' shaped ribs on it
48
RB3-1088-000CN Guide
Transfer inlet guide assembly - Angled metal guide between the registration roller and the transfer roller
50
WT2-5737-000CN Connector
Drawer connector - Connector located on bottom of tray assembly frame on right side, which connects tray assemblies to each other
7
RB3-0011-000CN Shaft
Feed drive shaft - Long shaft with eight feed belt ball type pulleys and one ribbed feed guide drive belt pulley
|